turret upper stretch for 250 mm and length of 2.5m
The upper section of 2.5 meters for 250mm turret is placed on a fixed base by a threaded link to support dynamic normal workloads. We have to choose the location of the base and the anchor points of winds on the ground taking into account the height of the turret to install to determine the distances from the base to the anchors.
This turret also has a steel tube 20 mm and corrosion protection.
This type of gun turrets are used in areas in which a great height is needed to install our antennas as there are buildings or trees that prevent a direct connection between our antenna and repeater, producing an shaded areas, causing us to have interference and even complete loss of the image on your television.
For installation of the turret connection, using screw links, a fixed base turret with recessed screw hooks which can be found at the following link is necessary.
This section is the top of the turret, so installing it on a fixed base is necessary to embed, ie can not be installed directly on the ground. For installation of a turret you can choose different combinations, depending on the height you need, we can "play" with the installation of the sections we want, for example:
Base - intermediate - higher.
Base - top, if we need high, but not too much.
Base - intermediate - intermediate - upper, if we need a considerable height.
In addition to these conjugates, we can choose many more combinations, provided the bolted go down Base and upper end is the upper section.
