Dual DUOX PLUS signal regenerator with 1 output to increase the installation distance and terminal load. It can be used to isolate sections of the installation against short circuits, load and signal reflections.
With this regenerator you can extend the distance to the board, as well as install more monitors and amplify the signal weakened by the distance.
The equipment has dimensions of 86 (H) x 89 (W) x 26 (P) mm and can be installed screwed to the wall or on a DIN rail.
Dual 1-output regenerator for DUOX PLUS line extension
What are the main functions of the Fermax Dual DUOX PLUS 3268 Regenerator?
The DUAL DUOX PLUS 1S Regenerator can be used for the following purposes:
Increased capacity of the installation in distance and / or terminal load. The regenerator must be connected at a point where the signal is acceptable (for example, where a monitor is working properly).
Plate distance extension.
Monitors extension.
Signal feedback.
Isolation of sections (trunks, ...). The two sections between which it is installed are isolated against short circuits, load and signal reflections.
When powered by one port, the regenerator allows a maximum current of 1.6 A to pass into the other port.
Also in modality as a multi-channel regenerator, establishing simultaneous conversations in different blocks.
TECHNICAL CHARACTERISTICS
Mounting can be carried out both by screwed fixing and by DIN rail installation.
Dimensions: 86 (H) x 89 (V) x 26 (P) mm.
Piping
The regenerator can be powered by either of its two ports, but not both simultaneously. If so, the regenerator will isolate the current between the INPUT terminal and the OUTPUT terminal, turning off for protection.
