The 1.5 meter upper section for the 175mm turret is placed on a lower section by means of the screw fixing to withstand the normal working dynamic loads. We have to choose the location of the base and wind anchor points in the terrain taking into account the height of the turret to be installed to determine the distances from the base to the anchors.
This turret also has a steel tube of 20 mm and anti-corrosion protection.
The upper section of 1.5 meters of turret has an external measurement of 175 mm, with sections plugged by screws.
What features does this turret have?
20 mm steel tube.
Calibrated rod of discontinuous lattice of 7 mm.
Tip sections for masts up to 45 mm.
Protection bluish white electrozinc anticorrosion.
Where is this type of turret used?
This type of turrets are used in areas where a high altitude is needed to install our antennas, since there are buildings or trees that prevent a direct connection between our antenna and the repeater, producing areas of shadow, which causes us to have interference And even completely lose the picture on our TV.
For the installation of the turret it is necessary to connect, by means of screws, a fixed base of turret to screw to floor, which you can find in the following link.
This section is the top of the turret, so it is necessary to install the same on another section, ie can not be installed directly on the floor. For the installation of a turret you can choose different combinations, depending on the height we need, we can "play" with the installation of the sections we want, for example:
Base - intermediate - upper.
Base - upper, if we need height, but not too much.
Base - intermediate - intermediate - upper, if we need a considerable height.
In addition to these conjugations, we can choose a multitude of combinations, provided that the base is screwed on the Base and at the upper end is the Upper Section.
175 mm Turret 2.5m intermediate sections€123.98 Tax included