VEO VDS connector for 9401 monitor

Connector VEO VDS

The 9402 connector is the connector required for the installation of the Fermax 9401 monitor.

The connector is a metal plate that, through four screws, attaches to the wall. Through the center we pull out the wires that reach us from the wall. In the VDS system are 3 common wires + 1 coaxial, 5 wires or CAT5 UTP so it would be normal that we had two connection cables. These cables are screwed into the connector at the corresponding terminals.

The next thing is to connect our VEO VDS monitor through the bus that incorporates the bus of the connector, and finally embedded on it. This greatly facilitates installation since we can easily work with the cables by connecting and screwing it to the terminals of the connector, without needing to be holding the monitor, and the monitor fits over the connector afterwards.

The image may not correspond with the item.